Testimonials
A few comments from some of our very satisfied customers.
You too can be amazed by Durafix Easyweld
|
".....for 10 minutes or so, I tried to destroy the joint with a 5lb club hammer but only succeeded in denting the tubing....IT IS ALUMINIUM...this is good stuff and I would not have believed it possible."
- S. C - Braintree
|
|
"...In general the product is easy to use if the instructions are followed....the kit gave me the flexability to cut and adapt as I need, as opposed to having to go forward and back to a specialist welder. I welded a couple of pieces together and tested them to destruction in a vice with a very large hammer! The joint stood up to the test very well."
- C. C. - Nottingham.
|
|
"...I wanted to fix a crack in a 1912 cast aluminium fly reel by hardys of alnwick. Eventually got around to trying the rods and they work great and almost produce an invisible joint."
- A. H. - Hampshire.
|
|
"...GREAT BUY !!!!!!!! THIS KIT IS TOP QUALITY!!!!!!!!!! AND VERY EASY TO USE !!!!!!"
- D. O. - Leicester.
|
|
"...Unsurpassable customer service , Cannot reccomend highly enough EXCELLENT A+++++ "
- T. C. - Norfolk.
|
|
"...This is an amazing product, I know that in the past I've scrapped stuff that was irreparable at the time, and now have an opportunity to effect a repair first..."
- J. B. - Lincoln.
|
"I have tried the product this weekend and I can only say one thing , its amazing ! I tried various stuffs like zinc plating and then nickle plating all without good results . The Durafix is wonderfull !"
- K Heernaert, RF Solutions - Belgium |
|
"I recieved the easy weld starter pack today ,saturday 21 st october. Its the best aluminium welding / brazing kit that I have ever come across.The results are magic and the instructions so easy to follow as I have used it already. Many thanks for a wonderful product."
- A. H. - Co. Down, N. Ireland
|
|
"I wrote to you recently re problems getting the rods to flow on a motorcycle crankcase I was repairing. I think I was probably asking for too much as the area around where I was building up was around an inch thick !!. However by putting it in the oven at max temp for half an hour ( wife was out !!) it stabalised the heat and I managed to fill the bits I wanted. I've since milled the area and was supprised how good it machined and the clenliness of the 'filler'. I think this will be a usefull addition to the toolbox."
- T R - West Sussex
|
"Just want to say thankyou very much for your swift service. I was amazed how I could get a really strong joint! I was amazed by how easily i could do it on my first practise attempt. I was amazed by the professional finish it leaves."
- D A - |
|
|
